everything look good, but my Zephyr doesnt work

[luminol]

Hello you all im expirment on my second xbox the next steps , but after all of this , no signal:

1.) ive read my nand but after pin headers , and just wires im getting error 250 : cannot read block E2 and after that 2CB block , try a lot of times compare look good but still got those errors on the same location.

2.) ive made with this nanddump.bin my ECC img file and write him to Box without any problem .

3.) write XSVF file on my COOLRUNNER done this ok.

4.) connect the cool runner really easy

5.) now when im trying to connect my box to tv im see every 3 sec green light blinking from my Cool Runner with the red light that on always.
but no signal and i cant see my fuse 3/5.

im think that because my damage read of my nand in E2/2CB .

what do you think ?

 

[Mickey3177]

You may want to resolder your NandX again, remove and clean it and resolder, some pics of your work would help us also. If you do get Xell to boot, take a picture of the screen. You may have to remap that bad block

 

[luminol]

its sound weird that i've the same block error on in every method im use QSB and wires , im going to picture it , and upload.

tried few times to see xell screen the green light of the xbox blick after 2 min im getting 3 red lights , but the Cool Runner keep blink green every 10 sec .

 

[luminol]

i've captured with my digital microscope (first time use ) , if you need my coolrunner pics too tell me.

for me those pictures of j1d2 j2b1 looking good ,
why the QSB and the wires give me the same errors in the same locations [email protected][email protected]?

 

[seanr28]

can not read block, is fine if all nand dumps are the same, you may well have to re-map them before creating your images

 

[luminol]

like i thought , but im little bit confuse about doin it.

my bads are E2 & 2CB what should i write to nandpro for remapping ?

 

[luminol]

Try everything remap it make the ecc write without problems , still no xell (no signal at all ) all the solders like charm , I'm think my Zephyr Halo 3 special edition is really special ...

What do you think back to original or try something ?

 

[Mickey3177]

bad blocks are common and you just remap them, put up some pics of the CR soldering points also.

Build your .ecc image with 360 Multi Build .3 and flash it with Jtag tools 4.23, this is what I did on my Zephyr and use the eject button to boot to Xell and this worked.

 

[MysterioMP]

Try everything remap it make the ecc write without problems , still no xell (no signal at all ) all the solders like charm , I'm think my Zephyr Halo 3 special edition is really special ...

What do you think back to original or try something ?

I'm also having the same problem with my Halo 3 Zephyr.
Everything looks good but it just won't glitch!!!

Coolrunner green light blinks every few seconds...I even flashed back to stock and it works perfect!!!!

What it up with this!!!! aaaahhhhhhh

 

[luminol]

tell me something you had problems with your NAND , (bad blocks...)

man until TX find the solution for us dont try nothing , ive try everything , even gave my father to solder (he is 30 years solder ... , and nothing from XELL side, hope one day we can glitch it , hope yours is not Hitachi drive , because LT 2.0 doesnt work properly ... like Microsoft said , Special Edition (CANT GLITCH / JTAG / XGD3) time to buy slim ...