Everything works....But now no CTRL PORT 2!!!

[vjkevlar]

I got my Executer 3 chip installed on my VER 1.0 xbox, a 200 gig drive (WEstern Digital), and Avalaunch.

Before i modded all controllers worked. Now the # 2 controller port will not work. Ive looked at the wires, and moved them around while it is on to see if the controller appears BUT NO LUCK!!! PLease help.

Everything works fine though. Games load, Dashboard, ect, ect, I can backup my games... but for some reason...No controller two. I tried several controllers as well.

If it could be the daughterboard, where can I get a replacement? Will Team Executer Send me a new one since I just recieved my chip?

ANY help would be greatly appreciated...

Kev

KEEP ON MODDING HOMEBOYZ

 

[HoBoZ]

did you look at the pins on the daughter board?

 

[vjkevlar]

SO now I took the controller port connecter from 3-4

and connected it to 1-2 connector port. STILL controller 2 will not work. Does that mean the daughterboard? How would this happen? is it expensive? Please help!!

 

[vjkevlar]

The pins? Which ones. Im assuming the one on the

daughterboard. hmmm its so weird because controller 1 works fine.

Thanks for the replies keep it coming!!

Kev

 

[vjkevlar]

Another problem.. I get the 'Needs Servicing' message

when I try to boot non chipped. Message # 13 in top left. Anyone know what that means?

But I guess I dont need that if I can get controller 2 workin!!!

Thanx again

Keep on Moddin!!!

 

[HoBoZ]

13 - kernel - Dashboard launch fail (due to missing/bad key, or anything else that would prevent it from running) and the dashboard didn't specify why it failed.

 

[HooDoo]

Ok first thing is first...dude dont post your first sentance as the topic of ur posts. It makes it hard to read....
With that said on to the problems

I am pretty sure that you are just having daughter board issues. Make sure that the board that the controller port wires plug into is pushed into the board good. Dont push too hard so you dont break it. If you cant seem to get it to work you can always buy one here http://secure.llamma.com/catalog/product_info.php?cPath=22&products_id=72

Second, how did you install your dash?? Was it just through FTP or did you use an install disk. Your best bet is to get an install disk like slayers and choose rebuild M$ dash. If you dont wanna download an install disk you could always put your old hard drive back in, ftp the contents of c back to your computer...then ftp them back over to your new hard drive. Slayers is easier though I think

 

[shagga]

Is it possible to connect ports 3&4 to the 1&2 connection on the motherboard to confirm it is a fault with the controller ports and not the motherboard. Make sure no pins are bent on the connection on the mainboard if the symptons are the same.

 

[shagga]

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&category=91526&item=8163250201&rd=1

May help if it is a problem with the controller ports.