LITEON 0225 Failing to Re-Write

[njacob2209]

Hello i have a liteon 0225 that i successfully flashed with the unlocked PCB. When trying to put the drive in vendor mode (through slimkey) i hit no , then yes, power cycle the drive and Slim Key always fails. I am wondering if i am missing a step. Help would be appreciated. thank you.

 

[demon2011]

If your trying to dump your key from you unlocked pcb then i'm sure you can't my friend, dump your key from the orig pcb then reconnect unlocked, set up the firmware in firmware 32 tab and go straight to part 9 in the guide.

http://www.team-xecuter.com/forums/showthread.php?t=67582

 

[Lizardpcs]

On the mtk tab just press intro then power cycle (if asked to) drive will go to vendor mode unlock you board then click read

 

[demon2011]

Well i learned something myself today, i was told that the key could not be read from a tx pcb but the way lizardpcs. Just tried that on a spare unlocked pcb and the way lizardpcs tell u works fine.

 

[njacob2209]

thank you i got into vendor mode by just clicking intro. When i flashed the drive back to ORIG, and then hit outro, it says no drive detected and now whenever i restart jungleflasher, it says my drive is missing.

 

[Lizardpcs]

Click outro several times

 

[demon2011]

As above, somtimes it does'nt go out of vendor mode the first time.

 

[njacob2209]

thanks for your responses. So where im at now is whenever i plug in the drive, it says "No Drive Detected". If i hit intro it will go into vendor mode. Whenever i hit outro, it says no drive detected again and even if i hit outro 10 times, my drive fails to eject.