Falcon 6754, CR Rev c advice

[GeekHeat]

Thank guys, I've decided to restart everything, not sure what I did wrong either soldering or bad write.
I removed all cables, reinstalled as RGH1.2, write Xell just to be sure CPU key is fine. write image, CR timing file 21 as suggested.
And Booooom, booting flawless almost immediately every time!

Thank you ppl, I appreciate the patience and helpful tips here, no where like TX

Try and get them boot times with rgh2 install.lol.

 

[Chura]

its the people here who make TX

 

[Chura]

Weird and maybe amateur question, but this Jasper, when I turn it off, keep fan on and power blinking. I taught maybe its to cool CPU down but it goes and goes.

Is it something with the installation or normal behaviour of Jaspers ?

 

[GeekHeat]

Weird and maybe amateur question, but this Jasper, when I turn it off, keep fan on and power blinking. I taught maybe its to cool CPU down but it goes and goes.

Is it something with the installation or normal behaviour of Jaspers ?

U probably have background downloads on in system settings. Google how to turn it off if u dont know.This can happen if u have wired controller plug in aswell

 

[Chura]

Hi

Well the downloads was off, but it was related to the cloud sync or something.

New thing, sometimes, the box just freeze! I'm not having too much luck with this specific one
is it wiring that cause the freezes ?

 

[GeekHeat]

Hi

Well the downloads was off, but it was related to the cloud sync or something.

New thing, sometimes, the box just freeze! I'm not having too much luck with this specific one
is it wiring that cause the freezes ?

It could be your wiring. Needs pics of install of your wiring routes.

 

[Chura]

Sorry for the late reply.
This box giving me hard time.

Following some reading I've re-routed the cables, and not I *think* its not freezing anymore.
But something is odd, When the board is out of cage, booting is immediate. when I get it back in the steel case, i takes long time, like a minute to boot.
I read that RGH1.2 should boot instantly. Change routing again ?

 

[GeekHeat]

U should always boot up and try different timing files wen its in the cage.
Try different timing files when in the cage. Also can be wiring route.
Like I said pics tell a whole lot more

 

[Chura]

 

[GeekHeat]

I don't like your CPU rst wire. It's wrapped around the xclamp.
I would change that as it will press on the wire when the screws are added to the xclamps when fitting the cage back on.

 

[Chura]

Well evantually I've configured the CR with file 12_20 and its kind of fine, less then 30 second, sometimes instant sometimes 10 second ...
Thanks for the patient!