Been really busy with home life/work etc and have just got round to posting the install of the CR4.
I must say its a snap to fit and the base results out of the bag are pretty damned remarkable. I have issues with my JR-P so no rater logs unfortunately, when I sort those issues out I will revisit the post.
Install Pics:






Boot times are 1 - 2 cycles, obviously I need to clean the flux spatter and remove the Nand read wires but it boots perfectly.
Default 4 and 8 dips on with 10 Ohm post bit jumper.
I must say its a snap to fit and the base results out of the bag are pretty damned remarkable. I have issues with my JR-P so no rater logs unfortunately, when I sort those issues out I will revisit the post.
Install Pics:






Boot times are 1 - 2 cycles, obviously I need to clean the flux spatter and remove the Nand read wires but it boots perfectly.
Default 4 and 8 dips on with 10 Ohm post bit jumper.