hello
Console Type: Falcon
NAND size: 16
Dashboard version: before R-jtag: 15574 & after 16537
CB version:5774 "i Think"
Screenshot of NAND details from J-Runner:
Image of R-JTAG board:
Images of close-up soldering to motherboard:
Description of problem:
i install the r-jtag to my xbox and it work good and i install Xexmenu , DL & freestyles but i have some question:
1-when i try to power on the xbox some times it give me red ring with code 0010, i disconnect the power and try several time until it boot, is it normal? if no then can you help me in this problem? note i double check the wire and i try the dip switch until i get the best result with 4 and 7 is ON and 330 ohm.but i have only one bin in qsb not connected (see 4th image in red arrow).
2-my r-jtag is written on it that it is R-jtag 1.0 and on IC there is "FWR 1.1", i check the serial and it's good , so is it 1.0 or 1.1?
3-can i go online to internet"not xboxlive" with jtag without banned my device
Was the console working before you started: Y
Console Type: Falcon
NAND size: 16
Dashboard version: before R-jtag: 15574 & after 16537
CB version:5774 "i Think"
Screenshot of NAND details from J-Runner:
Image of R-JTAG board:
Images of close-up soldering to motherboard:
Description of problem:
i install the r-jtag to my xbox and it work good and i install Xexmenu , DL & freestyles but i have some question:
1-when i try to power on the xbox some times it give me red ring with code 0010, i disconnect the power and try several time until it boot, is it normal? if no then can you help me in this problem? note i double check the wire and i try the dip switch until i get the best result with 4 and 7 is ON and 330 ohm.but i have only one bin in qsb not connected (see 4th image in red arrow).
2-my r-jtag is written on it that it is R-jtag 1.0 and on IC there is "FWR 1.1", i check the serial and it's good , so is it 1.0 or 1.1?
3-can i go online to internet"not xboxlive" with jtag without banned my device
Was the console working before you started: Y
