RGH Falcon: Coolrunner GL flashing but no Xell(Installation pics inside)

[MOCAMBO]

Ok so pics are below, let me know if you see any flaws that I should address.

I originally read the nand 4 times, all matching dumps with 1 bad block which was automatically remapped.

I have tried using both Falcon and Opus xsfv files.

I used multibuilder 0.4 to build ecc image.

After performing these steps, I tried to re-read the nand, it seems its not corrupt as 360 flash tool is saying its an unsupported image, fortunately I still have my 4 original good nand reads.

What do you guys think?

 

[n1ght0wl]

soldering on the QSB's need attention, and you can find out what board you have by opening up one of the nand images in 360 flash tool

 

[MOCAMBO]

soldering on the QSB's need attention, and you can find out what board you have by opening up one of the nand images in 360 flash tool

Could you tell me which specific points? I was under the impression if my QSB soldering was bad, I would either have bad nand reads or no Green light flashing on the coolrunner, neither of which have occurred to during my original run.

 

[n1ght0wl]

Could you tell me which specific points? I was under the impression if my QSB soldering was bad, I would either have bad nand reads or no Green light flashing on the coolrunner, neither of which have occurred to during my original run.

im very suprised you dumped your nand with lack of solder on them QSB's like that. take a look at your picture and see for yourself what needs attention.. it would be easier for me to tell you which ones look ok top up the points on the QSB's with a bit more solder

 

[RROD!]

can you give a better pic for A point under the gpu please also the solder looks like it has not taken to the wires in some points as if not enuff heat also can you test with your multimeter B point on the qsb is good one other thing have you tryed to do the rgh with coolshrimps tool??
just had another look i am sure you have B point of your qsb in the wrong place next pad down should be

 

[keith6625]

yes the QSB next to the hana chip is on the wrong pad move it down one and add more soldier to all the QSB points most look like the need a bit more in them

 

[Martin C]

can you give a better pic for A point under the gpu please also the solder looks like it has not taken to the wires in some points as if not enuff heat also can you test with your multimeter B point on the qsb is good one other thing have you tryed to do the rgh with coolshrimps tool??
just had another look i am sure you have B point of your qsb in the wrong place next pad down should be

Yep, QSB for point b is in the wrong place.




Sent from my iPad using Tapatalk.

 

[sick360mods]

Qsb need more solder and clean up the flux. As they said point b is in the wring spot

Sent from my PC36100 using Tapatalk

 

[MOCAMBO]

omg, you guys are right, I just rerouted to the alt point for B, booting XELL perfect.

Love you guys.

 

[thebomber]

congrats on solving and glad members helped out