JTAG Falcon Jtag wont boot and reflashed nand

[DigitalSniperz]

Hey guys,
I just reflashed my nand using a JR Programmer v2 and JRunner.

Heres JRunner

I just don't understand why it wont boot..

 

[BL4K3Y]

Is there any reason why you have purposely blanked out the Flash Config?

Can you please complete the JTAG/RGH support template properly.

 

[DigitalSniperz]

Nope, but I had a jtag working fine until I read the nand using Flash 360. Flash 360 some how broke my console and I thought I must have a corrupted nand. So I solder my JR Programmer to the board and flash the original nand and yet it still dosn't boot!

- - - Updated - - -

Nope, but I had a jtag working fine until I read the nand using Flash 360. Flash 360 some how broke my console and I thought I must have a corrupted nand. So I solder my JR Programmer to the board and flash the original nand and yet it still dosn't boot!

 

[DigitalSniperz]

Jtag Falcon not booting after a nand dump

Console Type: Falcon
NAND size: 16mb

Dashboard version: Not sure

CB version: Not sure

Screenshot of NAND details from J-Runner:

Image of R-JTAG board:

Images of close-up soldering to motherboard:


Description of problem: Falcon wont boot after dumping nand using Flash 360, I reflashed using my JR Programmer v2 to the original nand and it still dosn't boot!

Was the console working before you started: N

 

[DigitalSniperz]

JTAG Falcon not booting

Hey,
I have used flash 360 to dump my nand. When I went to turn the console on it didn't boot. I soldered direct wires for my JR Programmer v2 and flashed the original nand to the xbox still it dosn't boot. I am trying to return it to stock.

JRunner Log:

Motherboard & Soldering:

 

[chase]

Re: JTAG Falcon not booting

there was no need to make 3 thread within 45 minutes .. you should of just updated THIS thread

 

[xzanox]

Re: Jtag Falcon not booting after a nand dump

Nice, 2 threads about the same problem to keep it nice and disorganised... Why dont you fill in the complete template in your previous thread so it stays clear for everyone and you don't get messed up answers. Just a tip.

 

[Oggy]

Fill out the full template, or I'll just close this. I think 3 people telling you already should've been enough.