RGH Falcon...No green light on the CoolRunner

[krist]

Hi guys...
I tried to RGH a Falcon, first I dump the Nand:

nandpro usb: -r16 nanddump.bin
nandpro usb: -r16 nanddump2.bin

No differences found and no bad blocks.
Then I create Xell/Ecc glitch image with 360 multi builder and flashed the .ecc file to the Nand:

nandpro usb: +w16 image_00000000.ecc

Programmed the TX CoolRunner with:

NandPro xsvf: Falcon.xsvf

When I power on Xbox and try to boot to Xell the green led of the coolrunner does not flash.

I flashed back my original nanddump.bin, switch the coolrunner to program mode and the xbox work fine.

I don't have camera to post some photos. Anyone know what might be the problem?

 

[sick360mods]

It's stby_clk... Try resoldering it

sent from HTC EVO sick360mods.com

 

[krist]

Thanks... Tomorrow I try to re-solder...

 

[x23are]

also wire routing is important (away from coils)

 

[Goldensavage]

It's stby_clk... Try resoldering it

sent from HTC EVO sick360mods.com

Defo that one mate.

If your using the QSB you could try soldering direct to the point at the end of the qsb to ensure the connection is as tight as can be

 

[Martin C]

It's more likely to be CPU_PLL_BYPASS as this is where the signal comes from.