falcon not turning on after coolrunner installed
- Thread starter Budusy12
- Start date
x360ccm
BANNED
:facepalm::facepalm::facepalm:
if he didn't figure that out himself man..
did you even follow a tutorial?
if he didn't figure that out himself man..
did you even follow a tutorial?
knowlzy10
BANNED
x360ccm
BANNED
now thats a clearer pic chris
and now i seen that his wiring is about 6 inch out:facepalm:
its clear coz it's a uber pic lol
i wonder if his trace is still good because on his 'blurry' pic it looks like it has been attempted already
Martin C
VIP Member
the wire's not soldered in that pic - I think he desoldered it for a clearer image.
Folks - you have DIGITAL cameras (or digital cameras in your phones).
DON'T UPLOAD BLURRY PICTURES!! If you take a pic which is blurry, get more light and TAKE IT AGAIN. Don't waste everyone's time trying to make out what something is.
Folks - you have DIGITAL cameras (or digital cameras in your phones).
DON'T UPLOAD BLURRY PICTURES!! If you take a pic which is blurry, get more light and TAKE IT AGAIN. Don't waste everyone's time trying to make out what something is.
knowlzy10
BANNED
anyway if u aint managed to mess something up already:facepalm:
re-wire and follow a tutorial its not guess work. hope u can sort it but you definately need to re read tutorials and understand what your doing
re-wire and follow a tutorial its not guess work. hope u can sort it but you definately need to re read tutorials and understand what your doing
i know were the wire goes i had desoldered it to show the points i just soldered everywire back to were it goes read my nand twice compared it wrote my .ecc with mutibuiler wrote it to the xbox programmed the coolrunner with jtag tool when i go to turn on my xbox it doesnt turn on i have the switch to normal on coolrunner and phat wont turn on still please help on this thanks
Martin C
VIP Member
knowlzy10
BANNED
not very clear though martin as you say, that would explain why it looks about 6 inches away, no comments plz but why just a pic of that 1 wire does the op think there may be something wrong with that point?
but why just a pic of that 1 wire does the op think there may be something wrong with that point?
---------- Post added at 16:35 ---------- Previous post was at 16:34 ----------
theres the pic of the orange soldered on sorry if blurry tell me if u want anymore pics please anything to help me out
you soldered it ON the resistor?
that is the problem imo you need to solder it on the point in front on the resistor
as shown on ubergeek's pictures
that is the problem imo you need to solder it on the point in front on the resistor
as shown on ubergeek's pictures
not at all i desoldered the coolrunner completely and have the the nand x wires still soldered to the board i can still read my nand everything is good just the xbox wont turn on it turned on before and the middle light on xbox just blinked and thats all so i just resoldered it now the xbox wont turn on is there anything i need to remove.
your stby_clk point is screwed up thats the reason for not booting once the pad is destroyed the console will fail to boot(no green light nothing) look in the alt rgh point tutorial and you will see an alt point and how to repair damaged trace just had a clients board that wouldn't turn on and it was a screwed up resistor and pad combo(not by me it was a failed rgh attempt)
Last edited:
are u sure because my point looks nothing like the one in the pic that shows the alternative points and how it looks messed up in the first place il try this hope it works.