Team-Xecuter Community
I am working on a falcon R-JTAG here, managed to get it to boot Xell ok but whenever i put the mobo back into the case, the front ROL board LED's stop working, the unit boots for a few seconds and then shuts down or refuses to boot at all.
when i remove the mobo and let it sit for a while, the front ROL board functions normally.
i have tried putting insulation tape all over the jtag qsb but it isnt helping
i have the qsb soldered up as aud_clamp, and i did solder to the resistor connected to the 1 point but its solid.
when i return to stock all functions normally but i havent tried it in the case.
what am i missing?
when i remove the mobo and let it sit for a while, the front ROL board functions normally.
i have tried putting insulation tape all over the jtag qsb but it isnt helping
i have the qsb soldered up as aud_clamp, and i did solder to the resistor connected to the 1 point but its solid.
when i return to stock all functions normally but i havent tried it in the case.
what am i missing?