Hello, yesterday i Reset glitch hacked my Falcon Xbox 360, got the stock nand running stock, compatible with live, and my cygnos nand running ggbuild. (both on the kinect dash). on the stock nand i decided to update it to play on live, so i connected it to live and it updated fine, then i decided to update the cygnos nand and change the key vault to a pre banned one so my stock nand wouldn't get banned. i downloaded the key vault off the internet, replaced it in the nanddump.bin, and i used multibuilder 0.5 to build a glitch image with the different keyvault nand. after doing that i updated the stock and cygnos nand (both using the USB port on the cygnos chip and cygnos toolbox), i plugged in my Xbox tried to boot it to the stock nand, and it got stuck, it showed the center light only lit up, and soon after, 3 RROD (top left, bottom left, and bottom right, with secondary code 0022)), i tried to boot into the cygnos nand and nothing happened, just the center green light lit up. so in order to fix this i tried flashing the Original nanddump files i took from each right after i installed them. the stock nand boots the same way, but the cygnos nand wont even turn on when i press the power button. i just want my RGH working again...please help (the key vault i used was taken from a xenon, could that have something to do with it?) (also when wireing the cygnos chip the instructions were unclear and i left out a jumpper between pin 7 and 4) (also when updating i never reverted back to stock)
RGH Falcon RGH with Cygnos wont boot, and RROD
- Thread starter 3RAD1CAT0R
- Start date
Correct me if im wrong but I don't think you can switch kv's anymore? But 0022 can be a soldering issue
I am new to this Xbox hacking stuff, but I do have a friend who has a jtag and he said you can still swap kv's without trouble
sick360mods
BANNED
0022 is nand issue. the problem is that te ldv value has changed by one. so just go into multi builder 0.7 and go to options.ini and look for this cpu ldv= and change it to one higher from ur original dump or just boot to xell and counts the ffffffffs
It's your LDV value I had same issue. Update Xbox with official XBL update then read nand again and use that nand to make new RGH image.
If its the LDV, how do I fix it? I found it in Options.ini and I counted the "ff's" in fuseset 7, there are 15 ff's in fuseset 7 and a 0 at the end, fuseset 8 is all 0's, can I have an example of what I should put in options.ini would I put 16 since its one higher than my original, or 0x16f because it needs hexidecimal numbers?
i don't know what that means...like i said before, i am a noob to all of this (including forums)
Martin C
VIP Member
I think you should send this to someone to fix it for you. This is a true definition of jumping in with both feet without a clue on how to swim.
"after doing that i updated the stock and cygnos nand"
Why did you reflash the stock NAND after updating it?? Makes no sense whatsoever. I could point you to a bunch of tutorials (including my stickys), but reckon it's a waste of time since you're flailing about here without a clue what to do next.
Right now, it MIGHT be salvageable depending on what you've done with the original NAND dump.
"after doing that i updated the stock and cygnos nand"
Why did you reflash the stock NAND after updating it?? Makes no sense whatsoever. I could point you to a bunch of tutorials (including my stickys), but reckon it's a waste of time since you're flailing about here without a clue what to do next.
Right now, it MIGHT be salvageable depending on what you've done with the original NAND dump.
http://team-xecuter.com/forums/showthread.php?t=77634
i think this is the sticky matin is referring to
i think this is the sticky matin is referring to
now the xbox is giving red light in bottom right corner, with secondary error code 1033
Last edited:
try unplugging hdd i had this issue when i updated my rgh to 14699. I had to redo dash launch and launch.ini
Ok, hello again everyone, today i have been reading up on all of this stuff and i understand a little more about what i am doing now, i get that i screwed up by not reading everything in the first place but that's what happens when your a teenage guy who doesn't like reading, i should of read it, but i didn't, that's the past and i can't change that now, so please stop stating that i screwed up and stop telling me to send it to someone else. please just help me with my problem. now, an update from yesterday. today i downloaded multibuilder 0.7 and made a new nandflash.bin, i flashed that to my Xbox and now i can boot into Xell with the eject button at least (i did notice the FFF's in fuseset 7 changed, there is one more than last time), but i still cant boot into the hacked dash, the Xbox will turn on and the cool runner will attempt to glitch a few times, then it gives me a red light in the bottom right corner, with secondary error code 1101, i can't find what this means anywhere on Google and i was hoping someone here could tell me what it means and how to fix it. also in multibuilder 0.7 i see there are new options for dash launch patches, i don't even know what dash launch is, let alone why i need it, if i do need these patches which option should i choose? (with default launch.ini, or with custom launch.ini) again please don't state the obvious (i don't know what i doing) please just post helpful comments as to how i can move ahead in getting this to work. Thanks!
Never mind, solved my own problem!!!!! =) simple + and - in nandpro will make all the difference! Thanks for all your other help though guys! Especially the LDV thing!!! Noob problem I suppose, I'm just glad I didn't fry my Xbox!
Just shows that you are right!, you do need to read more and take your time, you probably would have not needed to make this thread at all.
Martin C
VIP Member
Glad you got it sorted.
Don't waste people's time in future though. If you're told to go read something, go read it. Any similar posts of this nature will be automatically closed.
Don't waste people's time in future though. If you're told to go read something, go read it. Any similar posts of this nature will be automatically closed.