JTAG Falcon RoL Dead, Console boots

B

bladez360

Full Member
Jan 31, 2012
26
0
Console worked
rol board works

was using regular hdmi console jtag with diode to pin 6 on rol board
Buddy said it started throwing e79s
I started it rol was not working (No lights at al) went to e79
Wrote back original nand unsolder everything
Console boots fine rol Not working tho

Tried rewiring jtag same way e79
Aud clamp worked fine just no rol

Getting really confused on what this issue would be related too or what I have to do to fix it
I read a forum saying possible related to ARGON_DATA being messed up
Or smc related

any input?
 
S

superspeed

VIP Member
Feb 2, 2012
825
0
TX, USA
bladez360 said:
Console worked
rol board works

was using regular hdmi console jtag with diode to pin 6 on rol board
Buddy said it started throwing e79s
I started it rol was not working (No lights at al) went to e79
Wrote back original nand unsolder everything
Console boots fine rol Not working tho

Tried rewiring jtag same way e79
Aud clamp worked fine just no rol

Getting really confused on what this issue would be related too or what I have to do to fix it
I read a forum saying possible related to ARGON_DATA being messed up
Or smc related

any input?
Click to expand...
Did any of the points bridge?
 
B

bladez360

Full Member
Jan 31, 2012
26
0
rol board works in other xbox

---------- Post added at 22:20 ---------- Previous post was at 22:19 ----------

also the power button works on the board to turn on and off just no lights
 
S

superspeed

VIP Member
Feb 2, 2012
825
0
TX, USA
Sounds like it may be a problem with the southbridge but I could be wrong.
Edit: But the lights work on a different 360?

Edit #2 BTW the image must be created with the correct SMC or you will get E79.
 
Last edited:
B

bladez360

Full Member
Jan 31, 2012
26
0
??? What do you mean... Remember stock nand the rol still dont work.. audclamp maybe i just dont understand
One thing i forgot to mention
The diode was backwards when i looked at it the one that connected to pin 6
 
S

superspeed

VIP Member
Feb 2, 2012
825
0
TX, USA
If it was wired to the RF Board then you changed to Audclamp then you need to rebuild the freeboot image to the new method. As far as the RF Board not lighting up could mean a problem with the Rf module itself or southbridge perhaps I'm not totally sure on that. Will the controllers still sync up?
 
You must log in or register to reply here.