RGH falcon stopt glitching after 3 weeks

S

snoop123

Full Member
May 29, 2011
85
0
Netherlands
I hope there is someone ho can help me.
sorry for my bad english.
I only get a center green light and he dos not start up at all.
I checkt all of the wiring, thats all good.
And when a read my nand with nandpro v3.0.
He reads all of it en when i put nanddump.bin in 360 flash tool he says (couldn`t read file or this Image is unsupported).
What can i do aboud this.

Thanks
 
xbox360 hacker

xbox360 hacker

BANNED
Feb 28, 2011
1,405
0
united kingdom
It could be that the resistor was there for a reason and without it the strain of the extra voltage has caused the problem some one like martin would be able to better access the situation. If you have a backup of your glitched image you could copy that across and see if it solves your issue. does it boot into xell ?
 
  • Like
Reactions: snoop123
reefz3ro

reefz3ro

VIP Member
May 30, 2011
669
0
Pittsburgh, PA
Is the green light blinking on the coolrunner? if the coolrunner is not blinking green u might have RROD.

if thats the case flash back your stock nand and set coolrunner to prog and see if it boots
 
  • Like
Reactions: snoop123
S

snoop123

Full Member
May 29, 2011
85
0
Netherlands
xbox360 hacker said:
It could be that the resistor was there for a reason and without it the strain of the extra voltage has caused the problem some one like martin would be able to better access the situation. If you have a backup of your glitched image you could copy that across and see if it solves your issue. does it boot into xell ?
Click to expand...
No i have only a center green light and thats it.
can it be my nand, is it bad flash.
i am looking at it for 2 day`s and i downt now wath it is.

---------- Post added at 23:08 ---------- Previous post was at 23:07 ----------
reefz3ro said:
Is the green light blinking on the coolrunner? if the coolrunner is not blinking green u might have RROD.

if thats the case flash back your stock nand and set coolrunner to prog and see if it boots
Click to expand...
No only red light no green light.
The only green light that is blinking is in the center of de xbox slef.

---------- Post added at 23:10 ---------- Previous post was at 23:08 ----------
reefz3ro said:
Is the green light blinking on the coolrunner? if the coolrunner is not blinking green u might have RROD.

if thats the case flash back your stock nand and set coolrunner to prog and see if it boots
Click to expand...
No only red light no green light.
The only green light that is blinking is in the center of de xbox .
 
manwithoutname

manwithoutname

1
Jun 4, 2010
3,080
0
You should have obtained the secondary code and reported that as well.
 
  • Like
Reactions: snoop123
Hackerjac

Hackerjac

The Minifigure
Staff member
Troll Eating Dogs
Jun 2, 2010
1,332
108
Denmark
try google
 
  • Like
Reactions: snoop123
manwithoutname

manwithoutname

1
Jun 4, 2010
3,080
0
Most probably the PLL_BYPASS is shorting where it is soldered onto the motherboard.
 
  • Like
Reactions: snoop123
x360ccm

x360ccm

BANNED
Jan 18, 2011
3,616
0
south coast UK
trim the green wire by 1 or 2 mm then solder it back on.also test the resistor.i think it should read 980 or there abouts.it's a 10k resistor.

remove the coolrunner put stock nand back on see if it boots ok.
 
  • Like
Reactions: snoop123
You must log in or register to reply here.