Fan fast spin up then stop.

R

rogerdodger

Junior Member
Oct 27, 2012
21
0
Hello,

While attempting to get the cpukey on a corona with DGX has anyone had their fan do a fast 1sec spin up and then completely stop?
I'm trying to get the key off this one and I'm at a loss...
 
Last edited:
R

rogerdodger

Junior Member
Oct 27, 2012
21
0
well it has only done that twice so far.
The green debug stops blinking after a while, but nothing on post monitor nor xell showing up in my router's attached devices. I have also tried the alternative Ecc...
 
R

rogerdodger

Junior Member
Oct 27, 2012
21
0
no offtopic please guys, I updated the first post with a picture as rules require it...
I don't have JR logs but they're empty anyway, reading/writing the nand didn't indicate any warnings/errors.

Any ideas what to try ?
 
J

joker2009

VIP Member
Dec 21, 2012
281
0
rhode island
rogerdodger said:
well it has only done that twice so far.
The green debug stops blinking after a while, but nothing on post monitor nor xell showing up in my router's attached devices. I have also tried the alternative Ecc...
Click to expand...
while its glitching look at your router,where the ethernet cable from xbox is.
It should have a blinking/flashing color and that indicates something is happening. and continue to press the ip scan
This is what i did
 
jtag360.nl

jtag360.nl

VIP Member
Apr 7, 2011
462
0
B.o.Z. in the Netherlands
www.jtag360.nl
joker2009 said:
i had that happen to me on my first one....it died afterwards....
ps i just completed my first after killing 3 xboxes....
Click to expand...

Hahaha, that's why your name is Joker. You are kidding right?

Or.................not?

If so stop doing this to the Xbox's.

Back to OP.

Had this problem one time with a Corona V1, after a few glitches i did the same what you are telling. Then i toke out the PSU and plug it in again. After that i a had the key after 5 glitches. :)
 
Last edited:
  • Like
Reactions: Justice1231
R

rogerdodger

Junior Member
Oct 27, 2012
21
0
this setup meaning with the post monitor adapter and dgx ? not many I guess, around 10 or so ?
 
Martin C

Martin C

VIP Member
Jan 10, 2004
35,981
0
Scotland, UK
www.team-xecuter.com
More than one then, which is why I was asking.

I'm assuming the console still works when you write the stock NAND back? Jane you also reapplied thermal paste to the CPU?


Sent from my iPad using Tapatalk HD
 
R

rogerdodger

Junior Member
Oct 27, 2012
21
0
Yes the console works with stock, I flashed back the nand at some point and updated from 16197 to 16202 and started from scratch. I haven't lifted the cpu fan, i just lifted one corner of the X-clamp to be able to solder on the C5R11...but I've also tried FT3T10 and that little R4P4 (or something..).
 
You must log in or register to reply here.