LITEON DG-16D4S - SLIM Fast eject problem and new pcb

[myst77]

Hello

i have a console with 0272 drive (MCIX chip). i think there is a problem with it (fast eject, closes half tray only)

1) Can i replace it with a pcb from other drive i have?
The other PCB is 0225FW and Winbond chip

2) Will it be ok for playing and XBOX Live if i put the new PCB?

3) Do i have to put 0272FW with my key or 0225FW with my key?

Thank you

 

[x360ccm]

how did you unlock the 0272 drive.

yes you can use another pcb.but as it's a winbond you need to do the kamikazi on it to unlock it.

you would use 0272FW with your key.

 

[myst77]

thank you for the response!

i did mcix (everything OK)
the problem was because after many flashes. the power cables of the pcb were cut many times. i soldered them many times on the pcb. yesterday the "base" for the yellow cable on the pcb was "fade" and i can't solder the yellow cable on it.
i tried the opposite side of the pcb to solder it where the current line goes.
then that problem started

i have a 0225 winbond pcb from other drive (the pcb has kamikaze hack, everything OK)

So finally can i use this pcb with 0225FW and my key with no problem for LIVE ? make me happy
?

Thank you!

 

[x360ccm]

your drive 0272.

then you flash it with 0272 fw with your key.

 

[myst77]

Thanks!!!

will it be treated as i had the factory pcb on it?