ANSWERED Faultu Nand-x or not?

[Varezz]

Hello,

I bought a nand-x and was working fine. After flash a coolrunner it doesn´t detect on nandpro. I know its not my soldering since i manage to try it on another´s xbox´s with qsb installed and sucessfully rgh. Why it´s not working? Have one month in my possession. Can i replace a diode or something??'

Thanks

 

[Martin C]

"After flash a coolrunner it doesn´t detect on nandpro"

Explain what this means - what did you flash and how ?

 

[Krafter]

Silly question but did you try unplugging it and back in? Another trick is to plug it in before you plug in your console. Maybe that will help.

 

[Varezz]

Hello,


After i pogram a coolrunner i tryed to flash ecc nothing. I downgraded to v2 used nandpro 2.0 and the same "Cannot find flash controller". The yellow and red led are working, drivers ok, hear a sound when i connect to computer. When i put v2 on nandpro 3 says " Not correct arm version". I can program coolrunner fine, but i can´t read or write nand....

Regards

 

[Hackerjac]

post some closeup hq pic of your soldering

 

[Martin C]

Also read my NAND-x troubleshooting link and check your values on the NAND points.

 

[Varezz]

Hello,

As i said i try to read nand on others xbox s with qsb´s that is sucessfully glitched. Same error.

Best Regards

 

[Martin C]

Try a different PC, USB port or USB cable.

 

[Hackerjac]

if it works on the cr board it could sound like the cabel for qsb might be wasted

 

[frazzeld]

Try and flash your nandx back to v3

test on both consoles afterwards

 

[Varezz]

Hello,

I have tried on another pc, tried 4 diferent cables (from x360usb , ck3i and another) always same error. I will try to get someone to borrow a nand-x and try.

It is possible the nand-x not working reading, writing but works programing coolrunner?

PS: I have 2 diff cables that conect to mobo and no one works....

 

[Hackerjac]

well, next thing i would do is to check the socket on the nand-x you plug the wire in to see if all pins are there