Hello, I have a Jasper console and I've soldered everything already, the CR4XL, the small Nand-X QSB, JTAG ALT V3, JRP NAND-X/CR QSB V3 and all the wires. I have a JR Programmer V2 and some wires to connect it with, but I cannot find any tutorials on how to connect the JR Programmer to the QSBs and CR4XL. Also I did not check what size block the console is, is there any way to do it now because everything is soldered already.
Finished CR4XL install guide, what next?
- Thread starter adamdabadboy
- Start date
john mathews
VIP Member
http://team-xecuter.com/forums/show...yr-Opus-Falcon-Jasper-Install-Guide-(R-JTAG-) try reading the install guide:cool2:
Last edited:
Used an online guide to plug in the wires because there were no pictures for that. I've dumped the NAND, created a Xell Reloaded .bin file. Before I write the Xell reloaded file I want to know if you plug in the JR Programmer to the CR4XL or not. Thanks
john mathews
VIP Member
This is how my CR4XL and JRP are plugged in. The CR4XL has no connection to the JRP. Do I need to connect the CR4XL to the JRP, that is all I want to know.
john mathews
VIP Member
I know that the JRP is used for reading and writing the NAND. But for writing xell do you need it plugged in to the CR4XL?
john mathews
VIP Member
You need to read more before doing this.The CR4 XL is already programmed.You only read & write to the nand..