Firmware tool 32 help.... Unusual issue

[kilemal]

Hi, i'm posting this because i couldn't find a relating thread to my problem. I have the latest jungle flasher tool, and i extracted my key with no issues. When i select the dummy.bin and select yes to auto-load ix firmware everything is cool, DVD key is copied over. But when i select no to the auto-load, and load any firmware, the DVD key does not copy over to target and displays all FFFFF's and i can't edit that field apparently. Even if i select no, and manually load the firmware the auto-load was gonna load anyways same issue arises.

Any feedback would be appreciated, Thank You.

 

[dj_deknoi]

Is the source Or target Saying all FFFFetc, If you load your .dummy and it shows all fffff it might be a damaged extraction of your Key and Probe again to get the key from it again... If the Source loads your Key fine and you can see different things in the [email protected],
Just left of the KEY! right click and Click test Key, it should say the key matches.. This means your .dummy is fine..

Also When you load 2.0 or w/e has target the FW is set to ffffff, it doesnt have a code at this moment in time, you Need Put your code onto this FW i.e. 2.0, So if you Click yes to Auto load it once FW loads, Click the Spoof Source to Target button in the middle, Then you'll see both "top and Bottom" code match, if they do match you can go ahead and Erase and write..
If you manually Load 2.0, you still see ffffff because this is the Key to that FW, click the middle button "spoof source to target" and then codes will match again, then Erase and write...