First CR4

[niallo27]

I haven't done a RGH in a while. I have a phat here for a customer. Is the CR4 done in the same way as the all the other coolrunners. I have no QSBs does this matter.
Thanks

 

[Krafter]

I haven't done a RGH in a while. I have a phat here for a customer. Is the CR4 done in the same way as the all the other coolrunners. I have no QSBs does this matter.
Thanks

It can be done without QSBs. There's a couple threads in the CR4 Success section. However, the install is different. Make sure you have a look at the guides. I suggest using the R-JTAG option and not RGH2+.

 

[niallo27]

May be a stupid question but do you need to program the cr4

 

[skillet34]

May be a stupid question but do you need to program the cr4

No

 

[jasonscootboy12]

May be a stupid question but do you need to program the cr4

Nope, its already programmed. All you have to do is change the DIP settings on the chip.

 

[niallo27]

Nice one. Ok i have read the nand. Its all good. I selected R-Jtag in xebuild then created Xell-Reloaded.
Will i now write this to my nand i presume.
Cheers for the help

 

[skillet34]

Your doing this for a customer? Yes if everything is installed properly......get key build image etc Chip is different but process steps remain.

 

[niallo27]

Yes for a customer. Just double checking what i know. I have been soldering for years. No harm in asking to make sure is there. Thats what makes this place great.

 

[skillet34]

No harm at all. I just like to know all the steps and procedures before I attempt anything is all. Good luck hope it turns out well for ya. CR4 is a great chip. Enjoy