Not sure what i should be experinecing, i have wired up as per the diagram for PHAT wires from JR, i have seen threads where people remove the two resistors but not sure i NEED to do this ?, i have read my nand and have two dumps the same, i flashed CR revc and i have created and written ECC without problems, i am not worried about boot times at this stage, i just want to know its working, i am getting the flashing green led every 5-7 seconds but i dont get a boot at all. Anything i have overlooked ?
first RGH2 xephyr
- Thread starter loady
- Start date
scott1503
VIP Member
scott1503
VIP Member
I think there are only a handful that have booted from what I have read there worse than xenon rgh1
Taijigamer2
VIP Member
Your best bet is rjtag v1.1. But personally, like the others say, get rid as stock and get a jasper phat or a slim.
he will still nedd to reball/reflow. best for him to get a newer console. ask u said. jasper or slim
oO Elite Oo
VIP Member
Zephyr in general for RGH purposes are sh*t to work with. Its only good for two reasons, 1) collecting dust and 2) trash bin
Its a Xenon with hdmi port at back.
Its a Xenon with hdmi port at back.
Ha.. its already clamp fixed. ..its running lt. .. I can feel a gumtree coming on lol...
Last edited:
I want to put this back, i got as far as writing ecc, i have written back the original nand dumps but it is not booting, is this because i still have the CR hooked up ?..i dont want to remove it all only to have to put it back because i omitted to do something before?
EDIT: :facepalm: try plugging in the HDMI...wonder if that was the problem when it wouldnt glitch ?
EDIT: :facepalm: try plugging in the HDMI...wonder if that was the problem when it wouldnt glitch ?
Last edited:
Martin C
VIP Member