I have two issues here.
So basically I installed my coolrunner rev c successfully, just like on my Falcon, but it would boot to 0022. So I found that pulling 3.3v and stby.clk off would fix it. I first experimented by trying alt points for stby.clk and eventually broke the pad near the ANA. I think it was RROD because I didn't have xell written, which I thought was fine because on my Falcon I installed the cr first and it was fine.
Anyway, now theres a lifted pad. I'm not sure if the resistor above it is damaged.
Then, a glob of solder got in the chip to the left of the ANA chip, Looking closer, it looks like the 6th leg from the right might be missing... I can't tell.
- - - Updated - - -
BTW all I have is a solder sucker, no wick
So basically I installed my coolrunner rev c successfully, just like on my Falcon, but it would boot to 0022. So I found that pulling 3.3v and stby.clk off would fix it. I first experimented by trying alt points for stby.clk and eventually broke the pad near the ANA. I think it was RROD because I didn't have xell written, which I thought was fine because on my Falcon I installed the cr first and it was fine.
Anyway, now theres a lifted pad. I'm not sure if the resistor above it is damaged.
Then, a glob of solder got in the chip to the left of the ANA chip, Looking closer, it looks like the 6th leg from the right might be missing... I can't tell.
- - - Updated - - -
BTW all I have is a solder sucker, no wick
