RGH Flacon not glitching. Not sure about remap.

[keil423]

I have a falcon thats not glitching correctly. Green light flashes every 5 seconds but glitch isnt holding. Not sure if I remapped my bad block at 003d correctly. I'm sure this is my problem. Right now I still need to get xell to get cpu key.
Here are some screen shots.
do these all look right. I'm doing everything with Jtag tool V4.25
I will post pics of my soldering once I get back from a birthday party.
Thanks for looking

 

[d4rk_4ng3l]

Okay, first suggestion is KEEP your original nand safe. The NAND that you read FOR THE FIRST TIME without remapping BAD BLOCK or whatsoever.

Secondly, accoeding to your 360 Flash and Dump Tool BAD BLOCKS Have been ANALYSED SUCCESSFULLY. Do not worry about remaping those.

Just follow this guide from top to bottom start everything from the begining.
If you DUMPED your NAND before then IGNORE Dump/Read the NAND SECTION in the following guide

BUT DO FOLLOW THOROUGHLY the following guide

FiB3R's Glitch Guide

 

[keil423]

Found my problem while I was takeing photos:facepalm:.
She is yet another instant glitch now.:cool2:

 

[keil423]

my other three shots. Some of you should spot the error!:rolleyes2:

 

[XJonnyGunsX]

Was it the green one?

I was just going to say that even though I had my green wire connected under the CPU, I had terrible boot times. I went back and re-soldered it and I had 10 second boot up times. *scratches head*

I think that's the most finicky wire (the green one.)

 

[keil423]

Yes the green wire belongs on this point!

 

[keith6625]

opps................:facepalm:
at least you seen it and got it sorted and still had the balls to post the pic :biggrin:


and the rest of your work looks good too

 

[keil423]

Just goes to show that problems are usually at the falt of the installer not the equipment!

Allthough mine was still a little fickel with the bad block at 0X003d. Jtag tool is more than capable of remaping these for you as well! No need to manually do it in nandpro