Ok, i installed the chip using the pin headers...an executer 3....made my DVD with the rom exactly as the tutorial said, and it looked like it started to work, then the yellow erase progress bar froze about 1/3 of the way through, and i let it sit for like 15min thinking it just takes a while
So then i tried a HTTP flash, and same exact error, so i thought maybe it was the bios or something, and i went and got 1957 instead of 1959 and had the same error.
I'm pretty good with a soldering iron and all connections look good to me, but if this is a symptom of a connection not being made or crossed, please tell me to check it over again.
Also, maybe i am mistaken on this, but i thought i could FTP into the X3? if thats suppose to be possible, i cant do that either.
Finally, i would assume there is a tutorial, but i cant seem to find it. I am looking for info on using the flash bios backup, and anything related to indepth detail of how the banks work. I'd like to know if there is someway to boot from a working bank, then flashing a bank that i screwed up
Or, if anyone knows how i can get an external programmer for it, thats just as good----can the 2.6 programmer be used?
So then i tried a HTTP flash, and same exact error, so i thought maybe it was the bios or something, and i went and got 1957 instead of 1959 and had the same error.
I'm pretty good with a soldering iron and all connections look good to me, but if this is a symptom of a connection not being made or crossed, please tell me to check it over again.
Also, maybe i am mistaken on this, but i thought i could FTP into the X3? if thats suppose to be possible, i cant do that either.
Finally, i would assume there is a tutorial, but i cant seem to find it. I am looking for info on using the flash bios backup, and anything related to indepth detail of how the banks work. I'd like to know if there is someway to boot from a working bank, then flashing a bank that i screwed up
Or, if anyone knows how i can get an external programmer for it, thats just as good----can the 2.6 programmer be used?