LITEON 74850 flash gone bad, need some help.

C

cchaulker

Noob Account
Mar 13, 2011
6
0
Ok I have a phat liton that was flashed before and worked fine until the dah got updated. When I tryed to update I had a hard time getting it to go into vendor mode but after a few tries it went but when I tryed to write the new file I was getting an error and it wouldnt write so when I tried to get out of vendor mode my computer locked up and I had to restart. Now there is a single red light flashing and it says no drive present. I take it the drive is blank now and thats why it cant see it. Is there any way I can fix it. I stll have my org key file and bin. :facepalm:
 
N

Neverzinho

VIP Member
Aug 30, 2011
200
21
Portugal
That sounds like sata chipset incompatibility but if you say that you flashed it before that's out of the way.
If you got your key your safe, just follow the tutorial on how to flash it.
 
R

RickSizz

VIP Member
Nov 8, 2010
214
0
Standing in the rain
Reboot your pc, load up jf and click LITEON erase. Power cycle when it tells you to and you should be in vendor mode. Write your fw with key and should be good to go.

Also if that still fails try a different version of JF.
 
Last edited:
C

cchaulker

Noob Account
Mar 13, 2011
6
0
sata scard box says "pci serial ata and altra ata controller card" like I said before it worked fine until I had to reboot while it was in ventor. I tried the liteon erase again but nothing and now I have 3 red light flashing on the xbox. and jf stilll says that no drive detected.
 
poisins

poisins

VIP Member
Mar 3, 2011
164
0
Alūksne, Latvia
Flash using dos. Use L-O-Erase to get into vendor, and then write fw.
JF won't recognise drive, becouse there are no fw on it. Just get in vendor and write firmware.

Sent from my GW620 (OpenEve 2.3.4) using Tapatalk
 
You must log in or register to reply here.