When I try to flash the bios on a v1.4 I get a unknown bios error. When I boot it says read only I checked the chip and the red light is on. I disconnect the x3 pro switch to make sure that was not flash protecting but it still is comming up read only. Do I have a faulty switch on the chip I tried to flash with switch 1 and 2 on the rest off and 2 on and the rest off I tried to boot in backup mode but my xbox just frags
flash protect
- Thread starter ober0n
- Start date
read this thread on http flash: http://www.teamxecuter.com/forums/showthread.php?t=26153.
Use only X3 bios since you would handicap lots of X3 capabilities with evox bios. I would try disconnecting the cable to the Pro switch to see if it flashes. Make sure to use X3 2913.bin bios and not X3 2913v16plus.bios. While we are at it, why not flash to 2914 since it's newer?
Use only X3 bios since you would handicap lots of X3 capabilities with evox bios. I would try disconnecting the cable to the Pro switch to see if it flashes. Make sure to use X3 2913.bin bios and not X3 2913v16plus.bios. While we are at it, why not flash to 2914 since it's newer?
I just downloaded and tried v2914 still same error I have tried disconnecting the cable to the pro switch and still same error could I ftp with flash bios 3.0.1. that was a good thread but I dont think my problem is there Its the read only on the flash type thats giving me the problem I think
I have a similar problem. I have version 1.6 with a working 1959 flash. When I try to flash to 2913 or 2914 X3 config live states "please remove flash protect and flash again". I have tried both the regular and plus versions of each bios. The chip and pro switch both light up red(flash protect disabled), I have disconnected the pro switch cable, same result cannot flash. I have tried network, CDRW, CDR, DVD, load from HD, HTTP none will flash. I am using the standard A/V cable and original conroller.