Flashbios for a 1.0, should I copy v3.01 and delete 3.03?

[BCoon]

Ok, so when I flash my bios, I'll use the X2 (Xecuter 2.6 CE Lite for xbox 1.0). Since the chip is pre-flashed w/ Flashbios 3.03 AND 3.01, and I can only use 3.01; should I delete the 3.03, make sure 3.01 is in bank 2 and install X2 (which will automatically go into bank 1) so I have a backup incase something messes up?

 

[DJBOOBY]

flashbios 3.0.3 will work on v1.0 xboxs have you checked

 

[BCoon]

flashbios 3.0.3 will work on v1.0 xboxs have you checked

Ah, I thought I read that 3.0.3 will only work on 1.6 or something along those lines, and to use 3.0.1.

So, I guess my question is which one should I use and should I delete the other and copy the one I use into both banks so I have a backup after flashing?

This is for a 2.6 CE Lite in a v1.0.

 

[BCoon]

The reason I'm confused on this matter is bc of this post, #2:
http://www.team-xecuter.com/forums/showpost.php?p=75707&postcount=1

It says that 3.0.3 is for 1.6b, but will it work for all the other versions?

The reason I ask is that, when I intall my bios, it will automatically go to bank 1, overwriting flashbios 3.0.1, leaving me with X2 5035 in bank 1 and FlashBIOS 3.0.3 in bank 2.

If something were to go wrong, will 3.0.3 from bank 2 work? If not, I assume I would need to copy 3.0.1 to bank 2 before overwriting bank 1.

 

[DJBOOBY]

keep flashbios 3.0.3 when you flash your chip it will flash bank 1