flip the PCB splice block over make sure you have continuity going threw the block also some one the other day had a replacement board from factory with the wires swapped from the factory you may wont to post a pick of your install hope this helps you
LITEON DG-16D4S - SLIM Flashed 0225 succesfully, xbox won't boot.
- Thread starter Matthias Vance
- Start date
I did the probes from the screws, so it must be all right.
I took these images yesterday: http://imgur.com/a/Grsxo#0
I took these images yesterday: http://imgur.com/a/Grsxo#0
just double check the wires on the TX replacement PCB should be starting at load + black/red/yellow/green/white i think its a wire connection problem but it could be the PCB not likely
did you check from screws to tx pcb also check bottom of connocter block it has pins make sure your block is good i would relocate those wire in your picks if you havent yet that ant your problem but they should be moved to the oem locations have you checked ribbion connections reflashed pcb or anything else yet
I checked from the screws of the block to the connectors on the PCB. This is as far as you can go without having it connected.
Reflashed with stock a few times, re-did the wiring a couple of times, nothing.
I'm just going to RMA the PCB.
Reflashed with stock a few times, re-did the wiring a couple of times, nothing.
I'm just going to RMA the PCB.
make sure the wires have no nicks in them or when you button it up it will cause problems looks like the yellow wire in the pick is nicked at the top some looked pinched those wire are very thin wont take much
I told you I tested them with the meter, everything is great. No wire is pushed beyond it's limits, it looks a bit like that because it was secured / hidden away by default.
These same wires work fine with the original PCB.
Can we move on?
These same wires work fine with the original PCB.
Can we move on?
Hy
Have you compare the PCB ?
see here : http://www.team-xecuter.com/fakes/Clone_Photo-2.jpg
and here
Fake Xecuter CoolRunners / Xecuter Unlocked DG-16D4S PCB Warning !
Have you compare the PCB ?
see here : http://www.team-xecuter.com/fakes/Clone_Photo-2.jpg
and here
Fake Xecuter CoolRunners / Xecuter Unlocked DG-16D4S PCB Warning !
Thank you, I'm 100% sure this is an original. You can see the pictures I posted earlier in this thread. The store said they also didn't know about any other options, and I'm going to send it back tomorrow.