flashed jtag - green power led no video

[uk_dan2k]

anyone know the cause of this?

used a modifed 9199 dash as orig to upgrade to latest dash using jtag tool.

created the freeboot image, updated smc patches because i use alternative points, then flashed image.

on power up, green power led on rol stays green, no error messages but no dash either, no video.

help

 

[uk_dan2k]

just a quick note, i just applied the smc patches to my old 9199 modifed dash and reflashed it, and that dashboard loads up fine.

it must be something going wrong with jtag tool converting my 9199 dump to latest dash or if that is correct then a setting on the harddrive i'm missing so the dashboard will launch.

any ideas anyone?

 

[uk_dan2k]

also when i do flash the latest freeboot, and it gets stuck with no audio / video, just the green power led on and fans spinning etc.

if i start the console using the eject button, it boots into xell, is there anything i can do through xell to get a dashboard up and running ?

 

[optantic]

try the newest jtag tool which updated yesterday

 

[uk_dan2k]

i'm already using the latest version, coolshrimps mentioned using an original clean nand,
anyone know any guides and downloads where i can create an original from a donor falcon dump.
and inject my kv and whatever else needs going in to replace dummy data in the donor file?

since i only have hacked dumps and not my original

 

[Hackerjac]

well i also tryed using jtag tool when i updated my box, and coulden get it to work, then i tryed easy freeboot and voila it worked the first time

 

[uk_dan2k]

tried both so far, no luck.

coolshimps sent me another method i'm gonna try out in a min thou - fingers crossed