Flashed The Entire 2megs On X3, can i go back and try again?

[Firepuppy]

I just recently installed X3 mod chip on my 1.0 XBOX. So after reading a couple of posts on installing bios and wanting to finish this project quickly I went out and downloaded X3 3294 bios, burned it to a DVD and went ahead with the flashing. I managed to successfully flash the bios but I later (5 minutes ago) found out that I needed to select a different bank setting before flashing so I ended up flashing the entire 2 Megs worth of bios.

My question is:
Can I from this point go back and undo what I did and re-install the bios into a smaller bank?
Do I even need to do that?
How would I go about doing it?

I have searched these forums and couldn't find an answer I was looking for so if anybody is able to help I would greatly appreciate it.

PS. The dip switches on the X3 were always on the "factory default" setting.

~Firepuppy

 

[TeamX-cuter]

i am not for sure but if you use the 256k backup flash ( hold the power and eject button) your modchip indicator should turn purple and you should be able to reflash.......but maybe the 2000 also includes the 256 k backup flash

 

[matt77303]

Hi

no the backup flash is separate.

Matt

 

[Rookio]

Firepuppy, if the settings were on the 2MB bank then it would have started flashing at the beginning and stopped after 1Mb worth (thats all the information you gae it) So i am pretty sure your best bet is to set the switches to the 2nd mb bank (bank 5678) and flash a bios to that. You may even find that flashbios is still present on that bank.

I guess the other point is that you are correct. If you bios is running fine, then you don't need to reflash anything.