I have read many posts of similar problems but I had not find the solution.
- I have a 1.6b Xbox and I installed the X3CE chip. I used the rebulided PCB so I didn't use the jumpers. I used the pin header too. I made the soldering very good (I'm an electronic tech) and verified it.
- I had to configure the external switches to off on off off off to see the blue flash screen, otherwise I only have a black screen and the eject led turns from green and stays orange in 30 secs. even if I switched to on on off off off.
- I made the DVD with the X3 3294 Bios, a 100MB dummy file and a skins folder.
- I flashed the Bios X3 3294 with the off on off off off switch set, I saw the yellow and green bars filling up and then the Xbox turned off automatically.
- When I turned on the Xbox it turns on and off three times and then it starts to blinks from green to red. The MS Dashboard works perfect if I disable the modchip.
- I tried resoldering, using the Bank1 and looking if the modchip or the switch boards have bad soldering or something suspicious but found nothing. When I try to use Bank1 instead of Bank2 nothing apears in the screen and the eject led turns orange in 30 secs.
- Now I don't know what to do, please help.
- I have a 1.6b Xbox and I installed the X3CE chip. I used the rebulided PCB so I didn't use the jumpers. I used the pin header too. I made the soldering very good (I'm an electronic tech) and verified it.
- I had to configure the external switches to off on off off off to see the blue flash screen, otherwise I only have a black screen and the eject led turns from green and stays orange in 30 secs. even if I switched to on on off off off.
- I made the DVD with the X3 3294 Bios, a 100MB dummy file and a skins folder.
- I flashed the Bios X3 3294 with the off on off off off switch set, I saw the yellow and green bars filling up and then the Xbox turned off automatically.
- When I turned on the Xbox it turns on and off three times and then it starts to blinks from green to red. The MS Dashboard works perfect if I disable the modchip.
- I tried resoldering, using the Bank1 and looking if the modchip or the switch boards have bad soldering or something suspicious but found nothing. When I try to use Bank1 instead of Bank2 nothing apears in the screen and the eject led turns orange in 30 secs.
- Now I don't know what to do, please help.