Flashing 93450c to LT 2.0

H

HAndFulL

Full Member
Dec 5, 2003
73
0
Hi all,

I am looking to flash a liteon 93450c to LT 2.0 and I currently have the .bin file from the proboe read I did at the start (it currenttly has LT 1.1 on it). I was wondering what firmware file I should use in JF to flash it back to stock with. Do I just use the pre-13146 FW file, flash it to stock, then flash to LT 2.0?

I have done this on a different liteon (8 series) so was wondering if the method is the same?

Many thanks in advance
 
D

dj_deknoi

Loyal Member
Dec 26, 2003
486
0
yes mate, it's almost the same has the 8x series, But what i would do if I was you is 100% make sure that the .bin is to that Drive, simple way todo this is Load JF with your Drive connected, put it in vendor, Goto Firmwaretool32 and When asked to Auto load Click No, select you .bin has source, right click Left of "dvd key @" and Click Test Key.. It should key is Matched..
Then To Stock it it all depends What Dashboard your on, If you've got the latest one "which unflashed your xbox taking it" Goto IRC channel and download 2.0, "remember use Latest JF" Then you want chose the right Stock Liteon Firmware for your drive and Dashboard then download then and put the 2.0 Fw, Stock AND .bin in the Firmware folder located in the JF folder, Then load your .bin has Source, Load the STOCK has Target, Click Spoof source to target Button, Then erase / Write etc... Then connect to xbox Live and Do update if needed Then Connect xbox back to PC, Loads JF, Put liteon into vendor, Goto Firmwaretool32 and when Asked to Auto Load click Yes, LOOK in the Location text to make sure it loaded 2.0 and then see that code matches and Then again erase/write etc and your On 2.0 :)
 
You must log in or register to reply here.