This will be my 10th drive I've flashed before and I've never run into this. I updated the phat xbox to dash 15574 first and then I've loaded the benq drive into the latest jungleflasher 0.1.92
Everything loads up correctly until I decide to read the drive. The key reads all 7's. After searching extensively I hear that it means jungleflasher is reading the wrong place for the key. Did the most recent update move where the key was? And if so, how do I redirect jungleflasher to read the key?
I'm using the USBPRO to connect. Any thoughts on this? This is a fairly new drive and I know for a fact this device has not been pre modded. It plays like you just took it out of the box.
Everything loads up correctly until I decide to read the drive. The key reads all 7's. After searching extensively I hear that it means jungleflasher is reading the wrong place for the key. Did the most recent update move where the key was? And if so, how do I redirect jungleflasher to read the key?
I'm using the USBPRO to connect. Any thoughts on this? This is a fairly new drive and I know for a fact this device has not been pre modded. It plays like you just took it out of the box.