Flashing Help

[viktor2005]

Once the chip is installed (X3ce) do you flash the program FlashBIOS v3.01 (for 1.6) to the chip bios via its web interface?

Then do flash the x3 3294 Plus (for 1.6) to the same chip using the now installed flash Bios?

If I decide to slayers install do you use it instead of the x3 3294 Plus?

Thanks.

 

[islander223]

Once the chip is installed (X3ce) do you flash the program FlashBIOS v3.01 (for 1.6) to the chip bios via its web interface?

Once you have a successful installation, flashbios 3.01 is already in banks 1-4 (0n 0n 0ff 0ff dip switch position) or by pressing power + eject button together. To preserve Flashbios 3.01 on banks 1-4, boot to back-up bios by pressing the "POWER + EJECT" button and set the swith to "OFF ON OFF OFF OFF" position then flash with X3_3294_v16plus.bin...

If I decide to slayers install do you use it instead of the x3 3294 Plus?

You can only use Slayer's after flashing the X3 bios

 

[DJBOOBY]

below in this post are some webb sites before you do anything start reading till you have the nowhow to do what you wise go to the tutorials and read come back if you have a ????? then