LITEON DG-16D4S - SLIM Flashing LT without Replacement Bord ?

[ponuod]

Is ther a way to flash and use LT firmware on slims drives without replacement board, or
it's always original board has to be replaced to use LT ?

 

[ezzda1]

Yes there are a couple of ways to unlock the spi on 16d4s drives. Jungleflasher manual explains this.
16d5s and hitachi will need ltu 2 pcb and rgh to get the relevant information from the console.

 

[ponuod]

Aha, i read about kamikadze, but
the easiest way is to LTU board ! Right ?
This also apply to latest E consoles ?

 

[Martin C]

Did you read the JF Manual as advised?

 

[ponuod]

Yes, i did, but
i heard that some people just flash LT to original board after rgh, and
without any additional tools, and
wanted to check with you guys
in case i miss some mod-innovation for xbox 360.
So it's just a false alarm !
Thanks guys.

 

[alexander_1333]

Just a false alarm.

 

[Utmad]

Yes, i did, but
i heard that some people just flash LT to original board after rgh, and
without any additional tools, and
wanted to check with you guys
in case i miss some mod-innovation for xbox 360.
So it's just a false alarm !
Thanks guys.

Just because the console is RGH it still does not allow you to write firmware to it. You need some hardware and either a replacement PCB or a method of unlocking your existing one either kamikaze or sputnik depending on the chip you have on your PCB.

 

[ponuod]

Got it,
closed.