flashing nand through xell

[moody_007]

hello guys i have Corona V6 i dumped the nand normally wrote the ecc and booted to xell grabbed my cpu key and built the glitched image not when i try to write it using the Card reader it won't show my console in JRUNNER so i tried to write it using xell and doesn't work i put the glitched image named as updflash.bin but nothing work i put the xenon.elf with updflash.bin xell said Extracting... then black screen i tried to rename it to nandflash.bin as rawflashv4 said but nothing work, i tried another PC same thing and tried another usb stick and same problem console is booting fine when i remove the 4gb reader all i need is to write the image to my console
thanks for your time

 

[Slayertex6]

Need a bit more info. Did you reboot your pc or try another card reader yet?

 

[moody_007]

Need a bit more info. Did you reboot your pc or try another card reader yet?

i have 2 readers tried both of them and im 100% sure they are working fine because i used it to dump the nand before this strange issue starts and yeah i tried to restarts and tried another PC same issue and rawflash show me black screen

 

[Slayertex6]

Did you make sure you had at least 2 matching dumps before writing anything? I would go over and check the soldering points. Without some pics of the install, it's just a crap shoot to most of us.

 

[BL4K3Y]

RawFlash doesn't work with 4GB Corona consoles as far as I know.

The process for using the R/W kit correctly is:

1. Set Switch To R/W
2. Connect PSU To Console
3. Connect SD Card Reader To Computer
4. Click "No" At The Format Prompt

If you are asked if you want to format, it means the NAND was detected and it can be read/written to with J-Runner.