Flashing status bar is stuck! Fbios 3.0.0! w/x31959!

[spizzle]

Hey guys, I'm pretty new to the xbox hacking world, I've just installed my x3 on a v1.0, everything is kosher until I try to load new bios, I have tried http and cd, it detects the bios and attempts to install it i see the status bar go yellow then after that the green creeps up to about 1/4 of the way and stays there.... I have let it sit for several minutes and nothing happens, does it take this long to load a bios? I have my dip swiches correct on on off off off, I event tried having them all off off off off, still no go. the light around the eject is still flashing yellow/green.... any advice would be greatly appreciated!

s/2

 

[Computertrendy]

Try flashing to 5678: off on off off ( only switch 2 on). You can probably flash whatever you want to 1234 when you get config live up. The flashing process can be a little sensitive and buggy sometimes.

 

[spizzle]

Hey thanks for the response, I've tried off on off off for banks 5678, and same thing... i tried updating the flashbios to 3.0.3 from 3.0.0 just to see if I could write to the chip w/ on on on on , and it works... could it be a bad bin file? or are there any other alternative bioses I can get ? Also I know I can ftp if I have either X3CL or evox dashboard , question is ..can I have evox loaded w/out loading x3 1959? thanks

 

[twm3]

Nand-X & Jtag Kit

Hi Guys,

I'm using xecuter nand-x kit to Jtag my xbox I got the quick solder boards in but now I get the below problem

I'm using coolshrimps app to read the nand but I get an unhandled exception error access to the path c:\program files (x86)\Tech-Modz\JtagTool\ReadCMD.bat'is denied is that because

1. Drivers aren't install correctly or
2. My soldering is sh*t and needs to be re-done

Any help is appreciated

 

[twm3]

Re: Nand-X & Jtag Kit

I seemed to have got the app to work without the unhandled exception now I have another problem this time nandpro in CMD gives me

Looking for flash interface device
could not detect a flash controller!
Can not continue
Press any key to continue then the program shut down

Please please help

 

[twm3]

Re: Nand-X & Jtag Kit

1st problem was I had to run cool shrimps app as admin but biggest problem was my soldering is sh*t back to the drawing board

 

[mosely]

Re: Nand-X & Jtag Kit

Just use Nandpro dude, its simple and stable.