flashing v16 to x3 how long

[jamieg12]

How long should this take and when should i see progress bar shown in so many illustrations

 

[elborak]

Less than a minute, and virtually immediately (assuming you're flashing via the FlashBIOS).

 

[jamieg12]

load bios via fttp finds bios starts flash and hangs on flashing executer screen with warning never see progress bar

 

[Elusid]

Does it say something that has flashbios! in the error message?

 

[Poida^]

I had flashing videos to show this...

Right Click Save As:

• Disk Flash (CD/DVD)
• Network Flash-DHCP
• Network Flash-Static IP
• Cable Disconnected

 

[vincentn2k2]

Great videos. I saw something strange in the video though and thought that one of you will be able to provide an answer. For instance in the "Network Flash - DHCP" video, the screen shows that it found the BIOS over http and the size is 1048576 bytes. However on the next line it says "Found Flash: Xecuter3 (2048K) (01 ad). These two numbers don't match up. One is 1MB and the other is 2MB.

 

[abrocky]

you need to select the 1mb bios within the folder.
either:
X3_3294_old for 1.0-1.5 xbox
or
X3_3294_16plus for 1.6 1.6b xbox consoles

 

[Poida^]

Great videos. I saw something strange in the video though and thought that one of you will be able to provide an answer. For instance in the "Network Flash - DHCP" video, the screen shows that it found the BIOS over http and the size is 1048576 bytes. However on the next line it says "Found Flash: Xecuter3 (2048K) (01 ad). These two numbers don't match up. One is 1MB and the other is 2MB.

Not too sure about it. I thought it was just showing the chip it found and its size...
Bank selection still required to know where you are flashing. The size of the chip's flash rom is still the same all the time even if the bios is a different size.

Just probably forgot to note that I was toggling buttons and flash protect on and off at the start.