Flashing with replacement panel

[olfogie]

First off I can't get my box to do anything but frag. But what im first wondering is I purchased the front relacement panel that comes with the lcd and switches pre-installed and im not positive as to how to set the switchs on it to do a 1meg flash. As there is 5 switches and the first one is to enable or dis-enabled the flash protection im assuming it has to be set to off(red) and switch 1 and 2 pushed in to do a 1 meg flash. Would this be correct or am I wrong here? Thanks for any help offered.

 

[Poida^]

That is correct!
If you want to refer to this like the dip switch (1-4) are the same as buttons (1-4) and dip switch 5 is Flash Protect (Red=Disabled) for flashing.

As for your FRAG'ing you may have knocked something out of place if the switches aren't working or you could try the backup bios or unplug your switch cable to see if your switches are not working properly.

 

[olfogie]

Thanks for the info on the switches. The fragging about to drive me nuts as i've redone the lcp going on 3 times. This time I think however im going to subsitute the front panel switches with the ones that came with the switch to see if your suggestion just might be right. Thanks again.