RGH Forgot to update from 8955 before RGH

[Coragin]

Yep, Im a dumbass.

Anyways, flashing original nand back, 360 just sits there with a flashing green light. (Turned off the coolrunner but did NOT remove all wires)

Now assuming the coolrunner is not to blame, this is exactly what I did to put original nand back...

1. nandpro usb: -e16
2. nandpro usb: -w16 nand.bin
3. unplug power and wait a few min.
4. turn on.

Also tried this....

1. nandpro usb: -e16
2. nandpro usb: +w16 eccimage.ecc
3. power on with no nand image.
4. same green light flashing, no red lights
5. This was done with coolrunner attached and working as you can run xell on jtag after erasing the nand.


falcon 5771
used 360 multi builder v0.2
no bad blocks

any ideas?

 

[diaboliq20]

how did you create the ecc - which mobo is it?

 

[Coragin]

Oops sorry its a falcon 5771, used 360 multi builder v0.2

---------- Post added at 05:43 ---------- Previous post was at 05:40 ----------

AH HA! Used second nand image and it worked (See kids? This is why you ALWAYS make two!)

 

[diaboliq20]

lols - glad you're working - did you compare the NANDs after the first dump?

 

[Coragin]

Thats the odd thing, i did. Strange, but maybe I was just tired and missed a mismatch.

I read all the nands to all these boards all in one sitting. Didnt do RGH to them until after.

Funny thing is I was in the middle of updating and the thing over heated and screwed my update. So I was like, oh no you dont, reflashed the nand. (forgot to hook up fan)