guys you might have a difference problem than i did but, i found out after trying to short my nand out on the pins went back and check my soldering and found on the hanna chip i bridge the point beside r4b6 point. and now my nand writes with matching nand. but i error code 0022 gpu over heating. so i can fix that. before that fix it would not read nand or come on. so check that also.:cool2:
found problem why nand wont rite
- Thread starter dayton1
- Start date
Martin C
VIP Member
0022 is not overheating.
You MUST provide images of your soldering and wiring at any time you ask for help on RGH/JTAG.
You MUST provide images of your soldering and wiring at any time you ask for help on RGH/JTAG.
i looked on liamma web site for error codes it it says that error code was over heatin of gpu. i took off all the wires ond going to sell as is. is that web error codes wrong
---------- Post added at 09:34 ---------- Previous post was at 09:30 ----------
seems like my fan is blowing faster also. most of time when that happens you get red rings
---------- Post added at 09:36 ---------- Previous post was at 09:34 ----------
is some of those error code are wrong on that web site liamma?????
---------- Post added at 09:34 ---------- Previous post was at 09:30 ----------
seems like my fan is blowing faster also. most of time when that happens you get red rings
---------- Post added at 09:36 ---------- Previous post was at 09:34 ----------
is some of those error code are wrong on that web site liamma?????
Martin C
VIP Member
Just look on this site alone for 0022 and RGH as they are synonymous with each other.
The issue has nothing to do with overheating and everything to do with your soldering.
EDIT: I deleted your post. This is NOT a chatroom. Gather the information you want to post, THEN post it.
The issue has nothing to do with overheating and everything to do with your soldering.
EDIT: I deleted your post. This is NOT a chatroom. Gather the information you want to post, THEN post it.