Hi everyone, gr8 board with loads of good advice but i'm completly stumped on this one.
Have installed lots of X2.6CE + Xapt3r 1.6 lately but having FRAG problems with a 1.6b Xbox.
Removed all coating from the PCB & all the points using a fibreglass pen as per usual. Installed the xapt3r 1.6 no problems, all lighted up fine when powered on.
Flashed the X2.6CE with x2_5035_v16plus 512k on banks 1&2 using the X2.6 programmer, the flash verified OK
Connected the 5v adapter and sat the chip on the xapt3r. Turned on the box with chip enabled and FRAG. When I disable the chip its fine.
Have tried everything I can think of to get this up and running (exept for soldering). Have checked the points, cleaned them again, all seems fine to me but always FRAGs when the chip is turned on. Even tried flashing Evox M8 1.6 on bank 2, still the same result.
Out of ideas, can anyone provide me with some.
Cheers
Have installed lots of X2.6CE + Xapt3r 1.6 lately but having FRAG problems with a 1.6b Xbox.
Removed all coating from the PCB & all the points using a fibreglass pen as per usual. Installed the xapt3r 1.6 no problems, all lighted up fine when powered on.
Flashed the X2.6CE with x2_5035_v16plus 512k on banks 1&2 using the X2.6 programmer, the flash verified OK
Connected the 5v adapter and sat the chip on the xapt3r. Turned on the box with chip enabled and FRAG. When I disable the chip its fine.
Have tried everything I can think of to get this up and running (exept for soldering). Have checked the points, cleaned them again, all seems fine to me but always FRAGs when the chip is turned on. Even tried flashing Evox M8 1.6 on bank 2, still the same result.
Out of ideas, can anyone provide me with some.
Cheers