Fragging 1.6. X 2.6 Oin Header Install Help (but not when chip disabled)

[immortal001]

Hi Everyone,

This one is driving me f**king crazy.

1.6 X-Xbox Xecuter 2.6 Bank 1 Flash Bios 3.03 Bank 2 X2 5032

Have tried switching bios's around on banks.

When chip disabled boots to normal MS dash and all is fine...

When enabled reboots 3 times and then frags.
Have connected chip using Pin header and rebuld LPC

Have checked all solder points and when check pins as per [font=verdana, arial, helvetica]http://www.teamxecuter.com/forums/s...ghlight=voltage

I get

16 -- 15 3.3V
14 3.3 13 3.3
12 0 11 3.3
10 3.3 9 3.3
8 3.3 7 3.3
6 -- 5 3.3
4 -- 3 --
2 0 1 0.1

with the chip installed the voltages after it frags are (checking points ont he back of the chip

[/font][font=verdana, arial, helvetica]16 -- 15 3.3V
14 3.3 13 3.3
12 0.2 11 3.3
10 3.3 9 3.3
8 3.3 7 3.3
6 5.0 5 0.23
4 0.4 3 1.91
2 0.2 1 1.91
[/font]
[font=verdana, arial, helvetica]The voltages are all right before the chip goes in. when I boot it enabled it resets 3 times. blue light on chip remains and then the bastard frags. I've had the pin header in and out twice and have tried a different chip and different switch as these are apparently problems. can anyone help me??????


Cheers Immortal001
[/font]

 

[Fantmx]

Check to make sure the wires going to switches are completly connected on both ends. I would also check the switches themselves. Try using a multimeter on them.