I installed my nand x and boards for a falcon.
Then updated to 7371 dashboard.
Used cool-shrimp v 3.0 dumped nand then write Xell
After when I turned unit on to get the cpu key I got the E79,turned it off and put the jtag switch in the middle and worked fine and left it there now. No more E79
Then I create fb like this then chose write.bin
Now my dash says 12625 under system info
Is that good?
Then did efuse bridged method.
Im puzzled what to do next and how to do it,Im reading every where and getting over whelmed.
I like to install xexmenu,dash launch,freestyle dash etc.
Then updated to 7371 dashboard.
Used cool-shrimp v 3.0 dumped nand then write Xell
After when I turned unit on to get the cpu key I got the E79,turned it off and put the jtag switch in the middle and worked fine and left it there now. No more E79
Then I create fb like this then chose write.bin
Now my dash says 12625 under system info
Is that good?
Then did efuse bridged method.
Im puzzled what to do next and how to do it,Im reading every where and getting over whelmed.
I like to install xexmenu,dash launch,freestyle dash etc.
