From RGH to RGH 2 general questions

[Dante-Sparda]

Hello guys,
I've just read about TX releasing RGH2, that's awesome.
However, a few questions come to my mind:

1. In case RGH 2 doesn't work as well as RGH1 in a SPECIFIC case, is it possible to turn back to RGH by just flashing everythng back?

2. The TX original post says:

We were not quite ready to release this due to it's unstable boot times on older glitch hardware,

Am I right to assume the CR Rev B falls under "older glitch hardware"?

3. In order to use RGH2 the PLL_bypass point is no longer needed, instead 2 points that are a lot easier to solder must be connected.
I'm having trouble with a BB Jasper that Martin C and others have kindly supported me with (again: thanx). Assuming it is really the pll-wire that is giving me bad glitch behavior at cold CPU, would I benefit from just switching to RGH 2 with CR RevB and forgetting about the pll all along?

Thank you

 

[lio_x]

you cant revert back once you update to 14719 dash- and you cant glitch fat 14717/14719 with old RGH
if it wont boot quickly you should wait for CR ver 2

2.yes -rev b is old- ver2 (aka rev c) is the new

3. i never had any problem glithing BB jaspers so i asume you have soldering problem
the RGH2 alternative point is mach more easy so it could solve your problem

 

[Dante-Sparda]

Is the dash really relevant? The way I understand this, I can glitch whatver with rgh2, so even my current kernel, or not?