Yes noob here but tech so I might have a chance.
Have searched & read all similar threads so dont bite my head off.
Fresh install on Ver1.0 (before anyone asks with the pinheader and no there was no damage to the board) but there is a problem with the front switch panel. Quick power on gives the blue logo and the Flashbios 3.0.0 screen and detects all devices etc. Long power on gives no indication on the switch panel logo however normal boot is achieved (HDD led works).
Pressing both buttons only produces X3 mode with blue logo indication but there is a slightly different statement during startup, either way no purple.
Both power LEDs on the X3 chip are on, so I spose I did good.
Should I flash it and will this help?
**UPDATE** Problem Solved - A faulty lead from the X3 to the switch panel, dodgy QA.
See, things aren't always "our" fault.
Thanks for the help :roll:
Have searched & read all similar threads so dont bite my head off.
Fresh install on Ver1.0 (before anyone asks with the pinheader and no there was no damage to the board) but there is a problem with the front switch panel. Quick power on gives the blue logo and the Flashbios 3.0.0 screen and detects all devices etc. Long power on gives no indication on the switch panel logo however normal boot is achieved (HDD led works).
Pressing both buttons only produces X3 mode with blue logo indication but there is a slightly different statement during startup, either way no purple.
Both power LEDs on the X3 chip are on, so I spose I did good.
Should I flash it and will this help?
**UPDATE** Problem Solved - A faulty lead from the X3 to the switch panel, dodgy QA.
See, things aren't always "our" fault.
Thanks for the help :roll: