Frustrating Coolrunner Programming

[marshamods]

Is anyone experiencing this issue. I have both tried programming my coolrunners with a 360nandflasher and nandx on both a 32 bit setup and 64 bit set up. I continue to get this error.
NandPro v3.0a by Tiros

Looking for usb interface device
Compression InSize:0x593E OutSize:0x28C6
Arm Version:0003
Sending compressed data:0x28C6 bytes
Executing File
File execution FAILED! Status :0x0002
Press any key to continue . . .

Any help would be appreciated

 

[coolshrimp]

try this..
http://www.team-xecuter.com/forums/showthread.php?t=75400

also be sure nand-x is version ARMv3

 

[marshamods]

Alright thanks will give it a go, and yes it is.

 

[marshamods]

same result as before with your program shrimp. Thanks for the advice though

 

[bonsc]

I tried this but still getting the same error

 

[fez lightning]

You probably already checked this, but make sure the switch on the coolrunner is on NOR and not PRG.

 

[marshamods]

bahaha Thanks for the tip though

---------- Post added at 19:17 ---------- Previous post was at 19:16 ----------

I tried this but still getting the same error

glad to hear it is not only me. Maybe it is something that should be looked in to.

 

[bonsc]

no joy for me on both

 

[chewyb]

I had this problem trying to program one after it was installed. I had the power cord plugged into the 360 and kept getting that error. I unplugged it and it programmed fine

 

[bonsc]

my one is connected to my nand-x

 

[marshamods]

Im using external 3.3v/GND as I dont want to turn my console into toast if something goes wrong. Though, I will replicate that with my ck3 (power cycle)

 

[marshamods]

No luck with that either. Guys post your results also if you found anything to work.

 

[steveoo1]

marshamods what file are you trying to flash, when I flash with trinity.xsvf
it says "sending comressed data:0x2B50 bytes"

 

[bonsc]

Got my spare nand-x and nan-x to coolrunner cable coming this week so hopefully that will sort it

 

[marshamods]

marshamods what file are you trying to flash, when I flash with trinity.xsvf
it says "sending comressed data:0x2B50 bytes"

Yes, I am too trying to program the coolrunner for a trinity board.

 

[fez lightning]

Im using external 3.3v/GND as I dont want to turn my console into toast if something goes wrong. Though, I will replicate that with my ck3 (power cycle)

are you powering it while trying to flash? the coolrunner should only be connected to the jtag wires while you're trying to flash; no power.

 

[steveoo1]

Yes, I am too trying to program the coolrunner for a trinity board.

Maybe try to download the "coolrunner_xsvf_jed"
again, and replace the files in nandpro 3.0 and retry.

 

[marshamods]

I believe it requires 3.3v to operate correct?

 

[fez lightning]

I believe it requires 3.3v to operate correct?

not required for the initial .xsvf flash, and it might be causing a problem.

 

[chewyb]

Not with a usb flasher

---------- Post added at 21:06 ---------- Previous post was at 21:05 ----------

The extra power is what's causing your problem.