FT2R2 Broke

R

rallin0s

Full Member
Jul 4, 2010
31
0
and also i dont get the 0022 RRod right away it takes about 10-15 seconds to show up.

---------- Post added at 11:49 ---------- Previous post was at 11:44 ----------

im also just remembering i did take the dump before i upgraded my nandx and i read just yesterday on the forums that some guy dumped his nand before and after the nandx upgrade and the dumps do not match could that be the reason because i dumped them with the old nandx firmware and am writing them with the new nandx firmware?
 
manwithoutname

manwithoutname

1
Jun 4, 2010
3,080
0
Of course dumps won't match, different dash, console has been powered and data has been written to the NAND, etc.

I suspect your initial NAND dump that you used is corrupted. After updating to 13604, did you dump 2/3 times and compare dumps in nandcompare?

Using any of the alternate soldering points for the CoolRunner has nothing to do with SMC's and should work just as the original points.
 
Last edited:
R

rallin0s

Full Member
Jul 4, 2010
31
0
I never updated to 13604 yet i was just trying to glitch it on the old dash to get the cpu key the was just going to write modified 13604 like i have done before for the other 9 or 10 RGH mods i have done.
 
C

cicicleta

Noob Account
Mar 3, 2010
5
0
there are a lot of people with that problem, they can't flash again their original nand. So you should focus on make your Glitch run. Forget about write your original nand again at the moment in some xbox 360 is not possible. Try to get your Glitch run. It is possible.
 
T

trippy

Noob Account
Nov 7, 2011
6
0
I too have messed up my FT2R2 and now my 360 won't power up at all. :facepalm: I would really appreciate a little more detail on the proposed fix. I guess it looks to me like that wire with the resistor in the previously posted pics is in a completely different area of the board and it's a little hard for me to tell what's going on there. Thanks! :D

**--------Edit------------**
Ok, so thanks alot cicicleta for the pics. Finally got it sorted to where I have power, had to run a wire from the trace that leads to FT2R2 over to that point on top and from there over to the new STBY_CLK point on the resistor. So now I am back to powering on but no glitch.
 
Last edited:
R

rallin0s

Full Member
Jul 4, 2010
31
0
Thanks everyone i have finally got this falcon to glitch it still wont boot the original nand but at least i can get it to boot ggBuild does the console being banned have anything to do with the original nand not working because i have another one thats also banned and once trying the glitch it wouldn't boot the original nand.
 
J

josh1095

Senior Member
Aug 31, 2011
132
0
its amazing how much abuse these mobos can take. i gotta post pics of the insane damage that was done to mine and the fixes i had to do. quite extensive but she glitches 10seconds or less everytime now. i fn love the rgh
 
You must log in or register to reply here.