GENERAL get CPU Key if Dashboard 2.0.13599

[Oliver-N]

@ frazzeld: I did, but forgot it... sorry:rolleyes2:

@ knowlzy10: I stored it on an usb-stick and formated it later accidently. :facepalm: (Me = absolute awsome superhero *ironic*)
And I just try to read it first just to test the interface.

 

[Oliver-N]

What am I doing wrong now?
Still at the point of getting the right key into my new drive I`m stuck a little.

Everything works fine until I want to set the drive back to normal mode. Instead of the new Information of the drive nothing seems to happen after "Outro /ATA Reset"

The port even dont recognize a drive or it even opens anymore (whats a part of normal if its still in vendor-mode as I read in the jf-tut)

But Im still able to set in back into vendor-mode so I can retry it as often as I want...

But see my protocol :

Sending Lite-On-Erase request to port 0xE700
..............
Drive returned Status 0x0
....
Serial flash found with Status 0x72
Manufacturer ID: 0xC2
Device ID: 0x11
Flash Name:  MXIC(MX25L2005)
Flash Size:  262144 bytes
Getting Status from port 0xE700
SPi flash found with Status 0x72
Sending Chip Erase to Port 0xE700
Erasing:
Writing target buffer to flash
Writing Bank 0: ................
Writing Bank 1: ................
Writing Bank 2: ................
Writing Bank 3: ................
Flash Verification Test !
Reading Bank 0: ................
Reading Bank 1: ................
Reading Bank 2: ................
Reading Bank 3: ................
Write verified OK !
Sending Vendor Outro to port 0xE700

I'll be so happy when i got ready with this case

 

[Oliver-N]

DONE!!!

The error was in CK3i. At the Probe there is a small button as you know.
I don't know how, but I tried it a few times till the CK3i was in "automode".
The I pressed the button untill the status was back to 0x72 (or something similar)

The rest was as easy as it should be.

My xBox runs again with games.

Thanks a lot for helping me and be so patient.:biggrin:

But I got an other xBox with ROD, what will be the next playground... (But I will now first play around with my rgh-xbox.

 

[Ubergeek]

The error was in how you were using the CK3i

Please word things correctly in future.