TEST Getting Crash with demon

[BrockThunderjam]

You are correct, the ribbon cable takes the place of cr_en.

Also - have you put your switches in the correct position for the CR3 Lite? Refer to the guide. They are not in the pic you included on page 1.

 

[rentyman]

You are correct, the ribbon cable takes the place of cr_en.

Also - have you put your switches in the correct position for the CR3 Lite? Refer to the guide. They are not in the pic you included on page 1.

I have gone through several videos and tuts, right now my LK2 is bridged, LK4 1,2 bridged and LK1 bridged, LK2 untouched. S2 1,2 and 7 on and S4 6 on.

also in jrunner, i select retail radio on xebuild, then i make sure my xbox nand is loaded and run a nand dump, after it does its first dump it says header is wrong and switches the radio in xebuild to rgh2 and does second dump.
nands are same.

 

[BrockThunderjam]

Have you written anything to the xbox nand? Have you saved a clean dump of your nand when you first read it from your xbox?

Sounds like you either wrote your ecc to the xbox nand, or you are reading the demon nand after writing the ecc to it.

 

[rentyman]

Have you written anything to the xbox nand? Have you saved a clean dump of your nand when you first read it from your xbox?

Sounds like you either wrote your ecc to the xbox nand, or you are reading the demon nand after writing the ecc to it.

i likely did write an ecc at some point to the xbox nand and deleted the file. I should have backed up the xbox nand dump, didnt think id f it up so quickly and easily. I dont know if its still salvageable or bricked.

 

[BrockThunderjam]

So let's take a breath....

1 - Read the nand that is on the xbox mobo. (assuming it will spit out wrong header info)

2 - Write the nand to the demon

3 - Try to boot and report back what happens.

 

[rentyman]

I'll try when i get back home. but i think they are same. might have write the dump from the demon when i may have we to xbox nand

 

[Martin C]

Sounds like you two are happy to sort this between you.

I'll close the thread. Please continue comms via PM/Email.